Sony — Device Setup Parameters

These Sony models need parameters entered in Xyte after they're claimed. Families that need the same parameters are grouped together below.

Authentication Code

Applies to:

• Pro BRAVIA

Parameters

• Authentication Code (required) — Set the authentication code in Network Settings on the TV

📘

On the device first

On the display, open Network Settings and set/enable the authentication code, then enter it here.

The Add credentials dialog for these models shows exactly these fields:

Password, Port

Applies to:

• Projectors (PJLink Enabled)

Parameters

• Password (optional) — Provide the password if enabled for this projector
• Port (optional) — Fill this field if the projector is using a non standard port

📘

On the device first

On the projector, turn on PJLink / network control and set a PJLink password if one is required. Leave Port blank unless it was changed from the default 4352.

The Add credentials dialog for these models shows exactly these fields:

Where to enter them

Both routes open the Add credentials dialog shown above.

From the Devices table — select one or more devices that need these same parameters (they show Missing Credentials), then click Add Credentials in the action bar. The button is enabled only when every selected device has identical requirements (usually the same model):

From the device page — open the device (it shows the isn't reporting data yet banner), then ⋯ → Edit:

Once saved, the Missing Credentials flag clears and the device starts reporting — your confirmation it worked.