Cisco — Device Setup Parameters

These Cisco models need parameters entered in Xyte after they're claimed. Families that need the same parameters are grouped together below.

SNMP community string

Applies to:

  • C9300
  • CBSx series

Parameters

  • SNMP community string (required) — Community string used for reading values via SNMP protocol
📘

On the device first

Enable SNMP on the device and set a read-only community string, then enter that same string here.

The Add credentials dialog for these models shows exactly these fields:

Add credentials ✕
SNMP community string *
CancelSave

Username, Password

Applies to:

  • Room Bar
  • Room Kit (EQ, EQX, Pro)
  • Room Navigator

Parameters

  • Username (required)
  • Password (required)
📘

On the device first

Use a local user with the Admin role, and make sure SSH is enabled (NetworkServices SSH Mode: On, the default).

Sign in to the device once with that user (web interface or SSH) before entering it in Xyte. If the device asks you to set a new passphrase, for example on a newly created user or one whose passphrase expired, set it and enter the new passphrase here. Until that's done, the device accepts the login but closes the session before Xyte can read anything, so the device shows as online with empty details.

The Add credentials dialog for these models shows exactly these fields:

Add credentials ✕
Username *
Password *
👁
CancelSave

Where to enter them

Both routes show the fields above (in the Add credentials dialog from the Devices table, or Edit device credentials from the device page), together with the model's setup instructions when it has any.

From the Devices table — select one or more devices that need these same parameters (they show Missing Credentials), then click Add Credentials in the action bar. The button is enabled only when every selected device has identical requirements (usually the same model):

Devices
☑ C9300StandaloneCisco🔒 Missing Credentials
1 Selected:CommandsMove DeviceAdd CredentialsDelete

From the device page — open the device (it shows the isn't reporting data yet banner), then Manage → Edit device credentials:

Devices › C9300
C9300  Cisco · Standalone
This device isn't reporting data yet

Open Manage → Edit device credentials to add its parameters. The device may still show as reachable, but it won't report data until they're set.

Once saved, the Missing Credentials flag clears and the device starts reporting — your confirmation it worked.


Did this page help you?