Crestron — Device Setup Parameters

These Crestron models need parameters entered in Xyte after they're claimed. Families that need the same parameters are grouped together below.

Username, Password

Applies to:

4 Series
AirMedia Series
CEN-ODT-C-POE
Crestron Flex Conferencing Kits
Crestron Flex Phones
Crestron Flex Soundbars
Crestron Mercury
DM Matrix Switchers
DM-NAX Series
DM-NVX-DIR Series
DM-NVX Series
HD-MD 4KZ AV Switchers (REST)
IV-SAM Series
TSS/TSW 4-Series Touch Panels
TS/TSW 60 Series Touch Panels
UC Engine

Parameters

Username (required)
Password (required)

The Add credentials dialog for these models shows exactly these fields:

Add credentials ✕

Username *

Password *

👁

CancelSave

Where to enter them

Both routes open the Add credentials dialog shown above.

From the Devices table — select one or more devices that need these same parameters (they show Missing Credentials), then click Add Credentials in the action bar. The button is enabled only when every selected device has identical requirements (usually the same model):

Devices

☑ 4 Series

Standalone

Crestron

🔒 Missing Credentials

1 Selected:CommandsMove DeviceAdd CredentialsDelete

From the device page — open the device (it shows the isn't reporting data yet banner), then ⋯ → Edit:

Devices › 4 Series

4 Series Crestron · Standalone

This device isn't reporting data yet

Open ⋯ → Edit to add its parameters. The device may still show as reachable, but it won't report data until they're set.

Once saved, the Missing Credentials flag clears and the device starts reporting — your confirmation it worked.